V-Paneling Cutter Sets

These cutters sets are designed to make V-groove paneling with a strong tongue and groove joint. Each set can be used with 1/2", 3/4" and 1" stock. Shims are included to allow the thickness of the tongue to increase as stock increases. UP190 cuts a V-Groove on both sides of the paneling, while UP191 only cuts a V-groove on one side.

 

Click here for Profile Knife illustrations.

Part No#	Overall Diameter (D)	Cut Depth (C)	Carbide Height (H)	Minor Height (m)	Tenon Thickness (T)	Tenon Length (L)	Bore Dia.	Price
UP190	4-1/8"	19/64"	31/32 - 1-5/64"	19/64"	3/16" - 19/64"	19/64"	1-1/4"	CALL
UP191	4-1/8"	9/32"	1-1/16 - 1-3/16 "	19/64"	3/16" - 5/64"	9/32"	1-1/4"	CALL

 

Designed for 1/2" and 3/4" thick stock, these cutters provide a strong joint for drawer fronts. Run the drawer face flat on the shaper table, and the drawer sides vertically on the fence. Once correct setup is attained for drawer front, height of cutter does not need to be changed to run drawer sides.

Part No#	Overall Diameter (D)	Cut Depth (C)	Carbide Height (H)	Minor Height (m)	Bore Dia.	Price
EC240	2-7/8"	1/8"	33/64"	5/32"	33/64"	CALL
UP240	3-15/16"	1/8"	1/8"	5/32"	33/64"	CALL

 

This cutter is used where very strong joining is needed. The cutter has three balanced wings and will join wood up to 5/8" thick. Wider boards can be joined by stacking multiple cutters on the spindle. After the first board is cut, the spindle should be raised or lowered 1/8" to make the mating cut.

Part No#	Overall Diameter (D)	Cut Depth (C)	Carbide Height (H)	Minor Height (m)	Angle (A)	Bore Dia.	Price
UP250	3-15/16"	11/32"	25/32"	15/64"	10°	1-1/4"	CALL