Please call Chuck Rankin at 828-628-4414 about the different specifications on this machine available and with any other questions.

Specs:

Year: 1986 
Mach #: 931-472
Electrical: 3 phase, 230v, HP: 1.5
Arbor Length: 9”  Max tool Dia.: 11-1/2”

Tilting head assembly for back relief grinding
Clearance angle on peripheral of tools: 10° - 30°
Side clearance angle: 0° - 20°
Variable speed via vari-speed gearbox
On board wheel dressing
Max grinding wheel Dia.: 9”          
Built in coolant tank with pump

Tolerances:

              Dresser up/down backlash:        0.0005”

              Wheel in/out backlash:            0.0000”

              Wheel angle backlash:             0.0000”

              Template left/right backlash:   0.0000”

              Template in/out backlash:       0.0000”

              Template holder alignment:  <0.0012” end to end

Replaced:

              New gear oil in gearbox

              New bearings in wheel arbor

              New brass bushing in template assembly

              Refinished armrest

              New fabricated metal belt guard (factory supplies plastic)

              New clear tubing for coolant system

             New Brass back clearance adjustment nut

Included with the following all new accessories:

          1    Gallon of coolant concentrate (makes 41 gallons)

          50  Sheets of filter paper

          1    Refractometer

          1    2mm tracing pin         (may substitute for

          1    4mm tracing pin               another size)

          10  Grinding wheels      (mix and match any specs)

          1    Dressing diamond

          1    13 pc toolroom assortment of honing stones

          1    Weinig profile catalog w/ CD    (1400 profiles)

          1    Weinig rubberized abrasive block

          1    Cratex rubber abrasive (6x1x1-1/4 fine)(may substitute)

          1    25”x2”x5/16” bar of corrugated knife steel

          1    Set of wrenches, 36mm and 24/27mm

          1    Gallon of Evaporust, multi-use rust remover

          1    Panther belt (installed)

          1    Operators manual

          1    Spare parts breakdown

          2    Refurbished grinding wheel collars

              Over a $1,300 value

 Also includes:

1    1-1/4” grinding arbor
1    Grinding wheel lock nut
1    Grinding wheel break-bolt

$15,000 • SOLD

Serious Inquiries Only Please
Call Chuck Rankin at 828-628-4414 with any questions.